When the filter press finishes filtration, you will turn off the equipment. In order to guarantee normal operation in next time, some follow-up works are necessary. Firstly, you should make sure that there is no residual filtering medium (wastewater...
When the filter press finishes filtration, you will turn off the equipment. In order to guarantee normal operation in next time, some follow-up works are necessary.
Firstly, you should make sure that there is no residual filtering medium (wastewater or slurry). Because residual materials will become dry and accumulate in the equipment after several days still standing. These dry materials will block equipment and influence normal start next time. Therefore, if you do not use filter press for a long time, you should thoroughly clean residual materials to prevent it from accumulation and dry.
Secondly, you should keep filter cloth wet, once you adopt it for filtration. During filtering process, liquid can pass through filter cloth, while solid materials will accumulate on the surface of filter cloth. After several filtration, filter cloth may be covered by some slurry. If you leave them for a long time, dry slurry on the surface will influence the filtration effect. You must wash or clean the filter cloth.
Finally, after turning off the equipment, you need to prevent water from entering into hydraulic pressure station.
If you want to keep filter press in high efficiency and long service life, you should do above-mentioned works after turning off filter press. If you want to know more information about filter press maintenance, please contact us by sending e-mail to info@bbnep.com.
Many people are very concerned about the price when purchasing a chamber filter press, but in the market its price on the market is also uneven. What is the reason for this?
1. Good sealing effect. 2. The filter cloth is easy, fast and safe to load and unload. 3. The moisture content of the filter cake is low. Compared with the original membrane filter press, the moisture content is reduced by 5%-10%, and the filter cake falls off automatically.
1. Electro-hydraulic, automatic pressure maintaining, manual pulling plate. 2. Automatic plate puller: controlled by a hydraulic motor puller plate appliance or an electric motor puller plate appliance. The puller plate can be numerically controlled to buffer, extending the service life of the filter plate handle, and can be paused or restarted at any time according to production needs.
Filtration Area:30-80㎡
Number of Filter Plates:23-62pieces
Filtration Area:15-40㎡
Number of Filter Plates:18-49pieces
Number of Filter Frame:19-50pieces
Filtration Area:10-20㎡
Number of Filter Plates:15-32pieces
Number of Filter Frame:16-33pieces
Filtration Area:15-40㎡
Number of Filter Plates:18-49pieces
豫公网安备 41019702003169号