Compared with most filter presses, the operating performance of chamber filter press machine is more stable. Its structure and working principle are simple, and the failure rate is very low. However, it is necessary for you to know more some common f...
Compared with most filter presses, the operating performance of chamber filter press machine is more stable. Its structure and working principle are simple, and the failure rate is very low. However, it is necessary for you to know more some common faults caused by improper operation or other reasons, and maintenance. In this way, you can deal with some emergencies immediately, so as to save time and keep working efficiency. BBNEP summarizes the following common failures of chamber filter press and maintenance, we hope they are help for you.
Many reasons may cause a lake of oil pressure, including improper adjustment of overflow valve, oil leakage in the valve, badly worn of cylinder sealing, external leakage of pipeline, solenoid directional valve is not in place, damage of plunger pump and oil level is not enough. If you find reasons, please replace or repair wear parts in time, and then the machine will work normally.
Reasons of this situation includes that low oil pressure, impurities on sealing surface of filter press, press cloth is uneven, filter plate deformation (using common filter plate to deal with high-temperature materials), too higher pump pressure or flow rate. You should check the equipment in time, and replace or repair corresponding parts.
For more information, please read following articles.
Many people are very concerned about the price when purchasing a chamber filter press, but in the market its price on the market is also uneven. What is the reason for this?
1. Good sealing effect. 2. The filter cloth is easy, fast and safe to load and unload. 3. The moisture content of the filter cake is low. Compared with the original membrane filter press, the moisture content is reduced by 5%-10%, and the filter cake falls off automatically.
1. Electro-hydraulic, automatic pressure maintaining, manual pulling plate. 2. Automatic plate puller: controlled by a hydraulic motor puller plate appliance or an electric motor puller plate appliance. The puller plate can be numerically controlled to buffer, extending the service life of the filter plate handle, and can be paused or restarted at any time according to production needs.
Filtration Area:30-80㎡
Number of Filter Plates:23-62pieces
Filtration Area:15-40㎡
Number of Filter Plates:18-49pieces
Number of Filter Frame:19-50pieces
Filtration Area:10-20㎡
Number of Filter Plates:15-32pieces
Number of Filter Frame:16-33pieces
Filtration Area:15-40㎡
Number of Filter Plates:18-49pieces
豫公网安备 41019702003169号